INFORMATION
In case of treatment interruption:
-
Let the mixture sit for a maximum of 8 hours. After that, it is no longer usable.
-
Perform the Cleaning after treatment interruption procedure.
-
Turn off the pump.
-
Set the valves to Cleaning Sprayer position mode.
INFORMATION
Do not use this 3D illustration as a reference. Please refer to the valve position modes table.
-
Engage the pump.
-
Activate Flushing mode on the app.
-
Spray approximately 100 L | 26 US gal on an untreated area.
-
Turn off the pump.
-
Remove and clean the suction filter (Cleaning).
-
If installed, remove and clean the section filter, located in the agitation tubing leading to Agitation1 and Agitation2 valves.
-
Reassemble the filter(s) and check for leaks.
-
When treatment is resumed, open Agitation1 and Agitation2 valves and agitate the mixture for 10 minutes (Agitation for fluidic kit (optional)).